______________________________________________________________________ Does anyone have wire connections for thios board. The board is a RAM-3MV5 Replies: Xenos Webmaster “Re(1):Lennox 33j6201″ , posted Thu 22 Apr 19:00 ______________________________________________________________________ That looks more like a serial or part number than a lennox model number. if you have the furnace model number email me for the manual. Xenos. The best way to escape a problem is to solve it. jtm-memphis “Re(2):Lennox 33j6201″ , posted Mon 10 May 14:06 ______________________________________________________________________ I’m having problems with my furnace blower. It is a Lennox G24M 4/5-120 furnace with a 33J6201 circuit board controller. I can get the fan to run in “cont” mode with heat and cool in the off position. But no fan when in the heat or cool position. Coming off the circuit board is the “cont”, “heat” and “Cool” connections for the fan motor. I swapped the “cont” and “cool” to verify the “Cool” winding was good. Fan did run. I think it is the relays on the circuit board. I would like to repair this circuit board but I don’t have a schematic. Can you help? Thanks, any help would be appreciated. John jtm-memphis Xenos Webmaster “Re(3):Lennox 33j6201″ , posted Mon 10 May 17:28 ______________________________________________________________________ Sounds like the relay however there are no schematics just wiring diagrams. Its illegal to repair a part form a gas furnace therefore they only see new parts. Xenos. The best way to escape a problem is to solve it.